RééDOC
75 Boulevard Lobau
54042 NANCY cedex

Christelle Grandidier Documentaliste
03 83 52 67 64


F Nous contacter

0

Article

--";3! O
     

-A +A

The reliability of quantitative analysis on digital images of the scoliotic spine

CHEUNG J; WEVER DJ; VELDHUIZEN AG
EUR SPINE J , 2002, vol. 11, n° 6, p. 535-542
Doc n°: 108175
Localisation : Documentation IRR
Descripteurs : CB2 - SCOLIOSE

Although analysis of scoliotic deformity is still studied extensively by means of conventional roentgenograms, computer-assisted digital analysis may allow a faster, more accurate and more complete evaluation of the scoliotic spine. In this study, a new computer-assisted measurement method was evaluated. This method uses digital reconstruction images for quantitative analysis of the scoliotic spine. The aim of the current study was to determine the reliability of the computer-assisted measuring method, which was done by establishing coefficients of repeatability for a variety of measurements. Measurements were carried out by five observers on 30 frontal and 10 lateral scoliotic digital reconstruction images. Each image was measured on three separate occasions by placing anatomical vertebral landmarks and drawing lines with a computer pointing device. The computer then calculated a number of geometrical shape parameters from scale calibration, landmarks and lines. The intra- and interobserver results were subjected to an analysis of variance to assess the level of agreement, and the means and standard deviations were calculated. The coefficient of repeatability (CR) was taken to be equal to two standard deviations. The mean intraobserver CR was found to be 3.1 degrees for the Cobb angle on the frontal digital image and 3.3 degrees for the kyphosis Cobb angle on the lateral overview. The mean difference in the intraobserver CR of the Cobb angle between measurements made by placing landmarks and those made by drawing lines was not statistically significant (P>0.05). The mean intraobserver CR for the other parameters can be summarized as follows: for lateral deviation it was 0.8 mm, for axial rotation 4.0 degrees and for length of the spine 3.3 mm. The interobserver bias was negligible. It can be concluded that the reliability of our new method for quantifying geometrical variables on digital reconstruction images is better than measurements on conventional roentgenograms in previously published reports. The presented method is therefore considered to be more accurate for research of spinal deformities and more adequate for clinical management of scoliosis.

Langue : ANGLAIS

Tiré à part : OUI

Identifiant basis : 2003226257

Mes paniers

4

Gerer mes paniers

0